Mould Kit for Grillz

How to take a mould of your teeth for Grillz

How to Use the Grillz Molding Kit

After purchasing from our site, and we’ll send you a free molding kit. Follow the instructions below and send the completed impressions back to us. We’ll work on your grills and ship them to you in about 10-20 Working days

Contents: Each kit includes, 2 sets of putty (2 white and 2 yellow), 2 impression trays (Top and Bottom) and a two-step solution syringe

Instructions

1) Take 1 mould kit (1 white and 1 yellow) out of its container and place them in your hand.
Note: Please wear the gloves that was provided to prevent dirt or dust from encountering the putties.

2) Mix the two putties together for 45 seconds until you have mixed them fully and none of the white putty is visible anymore. Do this quickly as the putty dries quickly

3) Place the putty into the tray and make sure it’s even inside. Also, do not let the tray over flow. Press down on the putty lightly to create a flat surface

4) Open your mouth as wide as you can, while showing your teeth to avoid your lips being in the way. Place the tray in until your teeth are right in the middle of the mouthpiece without being too close to the walls of the tray. Then push straight onto your teeth. Do not bite the mould. Push the tray up with your thumbs in a straight up motion Hold the tray in your mouth for 3 minutes. DO NOT MOVE OR TALK. Make sure the putty mix covers your teeth fully and your gums partially. If you are unsure if it is covering, your teeth fully, have a look in a mirror and push up if necessary. Your impressions must have a visible gum line where your teeth meet your gums.

5) After 3 minutes, pull your tray out of your mouth

6) Wipe the mould with a paper towel to remove excess saliva.

Before continuing, if you are unsure of whether the mould is good or not, please send us a DM on Instagram or email us @greenskullgrillz@gmail.com. There are 2 portions of putty just in case the first one does not go well

7) Hold your mould in one hand and the “2 Step Syringe” in your strongest hand. Squeeze the 2-step solution into the teeth you would like to be used for your set.

8) Place the tray back into your mouth and push the tray in fully. Hold the mould in place for 5 minutes to allow the 2-Step solution to dry.

9) After 5 minutes, pull the tray out of your mouth and rinse the tray with water. Then again wipe the impression with a paper towel to allow it to dry.

Your impression is now ready to send back to us! Please send the mould back to the return address noted on the back of the parcel you received
Back to blog